taney ethernet going up and down

| | Comments (0)
Taney's ethernet link seems to be going up and down:
[13275237.374946] eth0: port 1(peth0) entering disabled state
Dec 27 07:11:36 taney kernel: [13275240.495729] e1000e: peth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
Dec 27 07:11:36 taney kernel: [13275240.496284] eth0: port 1(peth0) entering forwarding state
Dec 27 07:12:17 taney kernel: [13275281.374172] eth0: port 1(peth0) entering disabled state
Dec 27 07:12:20 taney kernel: [13275284.454919] e1000e: peth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: None
Dec 27 07:12:20 taney kernel: [13275284.455487] eth0: port 1(peth0) entering forwarding state
The log on the switch just says something similar, with no errors counted on either end.

Luke is going to Market Post Tower now to try replacing the ethernet cable.
Update: Luke plugged the ethernet into eth1 instead of eth0 and it seems to be fixed now. -Nick

Leave a comment

About this Entry

This page contains a single entry by nick published on December 27, 2011 7:09 AM.

stone down hard was the previous entry in this blog.

hydra.prgmr.com is down is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.